Electronic crane scale signal instability how to do
The electronic crane scale can be roughly divided into two kinds: ordinary direct-viewing and wireless. The wireless electronic crane scale is used to transmit the results obtained by the weighing instrument to the display through wireless transmission. Therefore, it is very important to transmit signals. But occasionally there will be signal instability and even interruptions in the transmission of weighing values. What is this caused by it?
The most common reason is that the performance of the electronic hanging scale receiving transmitter is not good, and the signal can be transmitted through the cable for comparison and detection. If it is confirmed that it is a problem with the transmitter, it can be repaired according to the situation or directly replaced to eliminate the malfunction.
If the test indicates that the electronic transmitter is normal, other components such as batteries and antennas can be checked to see if there are any problems. In general, if the scale body battery is in poor contact, or if the antenna leads are not in good contact, signal instability will occur. In addition, signal instability may occur if the distance is too far or the battery voltage is insufficient.
Normally, two electronic cranes with the same frequency are used together, and signal instability or errors will occur. This should be noted during the purchase and installation process.
Elastic Modulus,Compression Platen,Concrete Test Cube Mould,Testing Machine Accessory
Jinan Chenda Testing Machine Manufacturing Co., Ltd. , http://www.jncdtester.com