Factors affecting the operation of the cone crusher
Cone crusher iron have means to prevent the crushing chamber through the iron, the iron if too frequently, it may cause breaking accident. To be fully loaded, otherwise the product size will be too thick. The crushing ratio in the production line should be reasonable, so as to maximize the efficiency of the crusher . The spring pressure should not be too tight. If the pressure is too high, the shaft breakage will occur. If the pressure is too small, the spring will jump frequently, affecting the normal operation of the crusher, and the product size will become thicker. The temperature of the lubricating oil should not be too high or too low, otherwise it will affect the operation of the machine. Lubricating oil should be replaced frequently, not too dirty. If it is too dirty, it will accelerate the wear of gears, bowl-shaped tiles, bushings, etc., and even kill the bushing. The drive belt installation should not be too tight, otherwise it will cause the drive shaft to rotate inflexibly or break. Also not too loose, otherwise it will cause the crusher to suffocate. Cone crusher feed can not be too wet and too sticky, fine particles can not be too much, can not be too large, otherwise it will cause boring. Accumulation of the discharge at the discharge of the crusher will also cause a boring car.
Because of its harsh environment and large dust, the cone crusher often has some maintenance problems. It often has various problems in operation. Generally speaking, the cone crusher should pay attention to the following problems in the operation. Keep the machine running.
Cone stone breaking machine is working, the feeding should be even and can not be segregated. If the feeding is uneven, the production capacity will decrease, the product size will be too large, the spring action will be frequent, the bowl bearing pressure will be large, and the power consumption will increase.
For each certain period of time, it is best to properly inspect and repair the equipment, which will keep the equipment in a better operating state after continuous production, and obtain better production capacity and finished product quality. The minor repair cycle is carried out every half month to one month. The contents include: checking the wear of the bowl tile, the taper sleeve and the straight sleeve and checking the gap, the bevel gear meshing clearance and the transmission bushing clearance.
Face roller Veneer Dryer machine is one of the roller veneer dryers . Face veneer dryer machine quality requirements are more higher than normal roller veneer dryer . The material is stainless steel , and the distance between two rollers is 140mm . the face veneer can be 0.3mm thinnest.
Drying Line,Face Veneer Dryer,Thin Veneer Dryer,Face Veneer Dryer Machine
Shandong Shine Machinery Co.,Ltd , https://www.woodmachine.nl