At present, most of the domestic smart lockers use bar code systems. This system is not only easy to operate, but also easy to manage, and its price is very popular. At this point, it is highly favored. However, we also know that the flow of people in supermarkets Very high, bar code paper will appear after a certain period of time out of paper phenomenon, this time we need to replace the bar code paper, but many managers do not know how to replace the bar code paper, so today Xiaobian to give everyone detailed The introduction.
First open the management box in the middle of the cabinet with the management key.
Then remove the rubber roller, set the barcode paper, and then put it into the paper shaft, pay attention to the correct paper release and use scissors to cut the top of the paper.
It should be noted here that there are positive and negative thermal printing papers. We should say that the heat-sensitive heating plate facing the head needs to be placed in the middle of the card slot, which is generally the outer surface. Do not walk or retreat with paper by hand.
Push the paper slowly into the input port of the printer port, and then press the Feed button on the printer control panel. At this time, the print head will automatically feed the paper.
At this time, we need to check it again. Press the memory key of the smart locker to check the print quality. If no font is found, it may be when we install the paper. When it is installed, we need to re-install it. If it is If the paper is not smooth, then you need to adjust the position of the printing paper so that it is centered on the center of the barcode port.
Although the installation process is relatively numerous, it is very simple when we are skilled. We only need to exercise regularly during our daily free time.
Note: When replacing the bar code paper, it is necessary to pay attention to whether there is foreign matter on the machine head.
Please keep the printer line clean and dust-free.
In order to ensure print quality and product life, it is recommended to use good quality thermal paper.
The printer head and heater plate should be cleaned regularly.
A mold is a special injection molding tool. Custom molded component manufacturers design and fabricate the mold specifically for the part they'll produce. When the production run for a part is finished, specialists replace the mold with a new mold for the next part they need to manufacture. Several types of molds exist for injection molding.
The mold determines the part's shape and size. It's also the special tooling in injection molding. When making large, complex parts, a mold may cost hundreds of thousands of dollars. When it comes to smaller parts, manufacturers can create molds with multiple cavities, adding to its cost. Incidentally, injection molding is most economical for large production quantities.
Plastic Injection Mould
Plastic Injection Moulding Parts,Mold Spare Parts,Parts Of Mould Tool,Injection Mould Machine Parts
KUNSHAN YSL PRECISION MOULD CO.,LTD , https://www.yslprecisonmould.com
